Name: Numerical Simulation of the Behaviour of Thin Parts During Milling de Felipe Klein Fiorentin(Ks Omniscriptum Publishing) (en Inglés)
Price: 52320.00 CLP
Availability: InStock
Author: Klein Fiorentin Felipe
ISBN: 9786207689750

portada Numerical Simulation of the Behaviour of Thin Parts During Milling de Felipe Klein Fiorentin(Ks Omniscriptum Publishing) (en Inglés)

Numerical Simulation of the Behaviour of Thin Parts During Milling de Felipe Klein Fiorentin(Ks Omniscriptum Publishing) (en Inglés)

Formato

Libro Físico

Editorial

Ks Omniscriptum Publishing

Autor

Klein Fiorentin Felipe

Idioma

Inglés

Encuadernación

Tapa Blanda

ISBN13

9786207689750

Numerical Simulation of the Behaviour of Thin Parts During Milling de Felipe Klein Fiorentin(Ks Omniscriptum Publishing) (en Inglés)

Klein Fiorentin Felipe (Autor) · Ks Omniscriptum Publishing · Tapa Blanda

Libro Nuevo Importado

Envío: 20 a 24 días háb.

$ 104.630$ 52.320

-50%

Costos de importación incluídos en el precio ✅

Libro Nuevo

Quedan 10 unidades

$ 52.320

Llega entre el 23 Jul y el 29 Jul a Santiago, Región Metropolitana. Seleccionar ubicación

Agregar a lista de deseos

Reseña del libro "Numerical Simulation of the Behaviour of Thin Parts During Milling de Felipe Klein Fiorentin(Ks Omniscriptum Publishing) (en Inglés)"

In marine engineering, thin parts such as propeller blades and heat exchanger fins are commonly used. These parts often undergo a machining process. Because these components are relatively flexible, machining them is a delicate process. The removal of material is inherent in any machining process, so variations in the mass of the part exist. In addition, as the geometry of the parts changes, variations in rigidity also occur. These two parameters determine the natural frequency of an object and, together with the damping factor, also determine the resonance frequency. Another factor that influences the rigidity of the assembly is the fastening system. You should avoid exciting these components at frequencies close to resonance. In order to minimize the vibrations of the workpiece during the machining process and consequently improve the surface finish, this study aims to use numerical simulation using the finite element method to predict the dynamic behavior of a given system by analyzing its vibrations. By correlating vibration amplitudes with roughness, it was possible to estimate the surface finish.